5,366
edits
Changes
no edit summary
This (re-)installs the [[Gen2/Motor Controller/Cover|Sevcon controller cover]] in the tail.
<onlyinclude>
;Prerequisites
# [[Seat Removal|Remove the seat]]
# Remove the [[SDS Platform/Y-Shaped Underseat Subframe|Y-Shaped Underseat Subframe]].
;Tools
* Small Philips-head screwdriver (PH1)
;Steps
# Lay the front of the sheet down around the connector wiring and cabling.
# Insert each side edge carefully under each side rail of the frame's tail section.
# Push the aft end of the sheet down towards the frame cross-piece behind the Sevcon controller.
# Fasten the sheet at the aft end with the screw using a small Philips Head (PH1) screwdriver.
</onlyinclude>
[[Category:High Voltage Procedure]]
<onlyinclude>
;Prerequisites
# [[Seat Removal|Remove the seat]]
# Remove the [[SDS Platform/Y-Shaped Underseat Subframe|Y-Shaped Underseat Subframe]].
;Tools
* Small Philips-head screwdriver (PH1)
;Steps
# Lay the front of the sheet down around the connector wiring and cabling.
# Insert each side edge carefully under each side rail of the frame's tail section.
# Push the aft end of the sheet down towards the frame cross-piece behind the Sevcon controller.
# Fasten the sheet at the aft end with the screw using a small Philips Head (PH1) screwdriver.
</onlyinclude>
[[Category:High Voltage Procedure]]