5,366
edits
Changes
link update
This replaces the [[Footpegs|rider or passenger footpegs]] on 2012+ S and X-Platform models.
: This is derived from [[Rider Footpeg Removal]].
<onlyinclude>
[[File:footpeg-retaining.jpeg|thumb|150px|footpeg retaining clip and tool]]
;Tools
* Snap Ring / E-Ring pliers (needlenose pliers are a common if less easy substitute).
* Pliers (for the spring).
;Steps
# [[Rider Footpeg Removal|Remove the footpeg]].
## Gently spread the gap in the retaining E-ring using the pliers until it slides over the end of the pin, and remove it.
##: This clip is on the lower end of the footpeg retaining pin.
## Pull the retaining pin up and out.
##: Hold and pull the pin spring and footpeg as the pin comes out.
# Install the new footpeg.
## Place the footpeg onto the bracket.
## Insert the pin through the top half of the bracket to hold the footpeg in place.
# '''Rider Footpeg:''' Install the spring on the pin.
## Squeeze the spring so it will fit through the bracket gap.
## Pull the pin partway out, insert the spring, and then push the pin back through the spring and the bracket to hold it in place.
# Install the footpeg retaining clip.
#: Use the snap ring pliers to enlarge the gap in the E-ring clip to fit over the end of the pin, then let it snap into place in the indented slot.
;References
: [https://www.youtube.com/watch?v=9OdBkfS_qbs How to Remove Zero Footpegs + Relocation Ideas] by NewZeroLand on Youtube
: {{#ev:youtube|9OdBkfS_qbs}}
</onlyinclude>
[[Category:Procedure]]
[[Category:Repair]]
: This is derived from [[Rider Footpeg Removal]].
<onlyinclude>
[[File:footpeg-retaining.jpeg|thumb|150px|footpeg retaining clip and tool]]
;Tools
* Snap Ring / E-Ring pliers (needlenose pliers are a common if less easy substitute).
* Pliers (for the spring).
;Steps
# [[Rider Footpeg Removal|Remove the footpeg]].
## Gently spread the gap in the retaining E-ring using the pliers until it slides over the end of the pin, and remove it.
##: This clip is on the lower end of the footpeg retaining pin.
## Pull the retaining pin up and out.
##: Hold and pull the pin spring and footpeg as the pin comes out.
# Install the new footpeg.
## Place the footpeg onto the bracket.
## Insert the pin through the top half of the bracket to hold the footpeg in place.
# '''Rider Footpeg:''' Install the spring on the pin.
## Squeeze the spring so it will fit through the bracket gap.
## Pull the pin partway out, insert the spring, and then push the pin back through the spring and the bracket to hold it in place.
# Install the footpeg retaining clip.
#: Use the snap ring pliers to enlarge the gap in the E-ring clip to fit over the end of the pin, then let it snap into place in the indented slot.
;References
: [https://www.youtube.com/watch?v=9OdBkfS_qbs How to Remove Zero Footpegs + Relocation Ideas] by NewZeroLand on Youtube
: {{#ev:youtube|9OdBkfS_qbs}}
</onlyinclude>
[[Category:Procedure]]
[[Category:Repair]]