5,366
edits
Changes
link update
<onlyinclude>
This replaces the [[Gen2/Front Bearings|front wheel bearings on Gen2 models]].
;Tools
* 6mm Allen Wrench - Axle (M17)
* 5mm Allen Wrench - Pinch
* 13mm Socket - Brakes
* Bearing Press Tool/Kit
;Steps
# [[Front Wheel Removal|Remove the Front Wheel]]
# Remove the spacers, then the dust seals, from each side and clean.
# Press the bearings out from the opposite side.
#: A socket extension works well, alternating around the perimeter.
# Clean the inner wheel.
# Press the new bearings in, aligning with the inner axle tube.
#: A large socket works well to press only on the ''outer'' bearing.
# Replace the dust seals.
# Return the wheel to the bike.
# Aligning the axle with the spacers, press the axle back into the forks.
# Expand the brake calipers to prepare for remounting.
# Remount brake caliper with the 13mm socket to the correct torque.
# Return the outer spacer and make the axle bolt snug with the 6mm allen wrench.
# Alternate tightening each 5mm pinch bolt.
# Ensure proper wheel movement.
# Tighten ''left'' pinch bolts to the correct torque using the 5mm allen wrench.
# Tighten the 6mm Axle bolt to the correct torque.
# Tighten ''right'' pinch bolt to correct torque using the 5mm allen wrench.
# Ensure smooth movement.
# Pump the brakes to return to proper action.
# Lower the front wheel.
# Confirm torques.
# ''Test ride!''
# Reconfirm torques.
# Paint the bolt heads to so that any loosening is detectable.
</onlyinclude>
[[Category:Procedure]]
[[Category:Repair]]
This replaces the [[Gen2/Front Bearings|front wheel bearings on Gen2 models]].
;Tools
* 6mm Allen Wrench - Axle (M17)
* 5mm Allen Wrench - Pinch
* 13mm Socket - Brakes
* Bearing Press Tool/Kit
;Steps
# [[Front Wheel Removal|Remove the Front Wheel]]
# Remove the spacers, then the dust seals, from each side and clean.
# Press the bearings out from the opposite side.
#: A socket extension works well, alternating around the perimeter.
# Clean the inner wheel.
# Press the new bearings in, aligning with the inner axle tube.
#: A large socket works well to press only on the ''outer'' bearing.
# Replace the dust seals.
# Return the wheel to the bike.
# Aligning the axle with the spacers, press the axle back into the forks.
# Expand the brake calipers to prepare for remounting.
# Remount brake caliper with the 13mm socket to the correct torque.
# Return the outer spacer and make the axle bolt snug with the 6mm allen wrench.
# Alternate tightening each 5mm pinch bolt.
# Ensure proper wheel movement.
# Tighten ''left'' pinch bolts to the correct torque using the 5mm allen wrench.
# Tighten the 6mm Axle bolt to the correct torque.
# Tighten ''right'' pinch bolt to correct torque using the 5mm allen wrench.
# Ensure smooth movement.
# Pump the brakes to return to proper action.
# Lower the front wheel.
# Confirm torques.
# ''Test ride!''
# Reconfirm torques.
# Paint the bolt heads to so that any loosening is detectable.
</onlyinclude>
[[Category:Procedure]]
[[Category:Repair]]
