Gen2/Charging Circuit Fuse

From Unofficial Zero Manual
< Gen2
Revision as of 23:52, 18 April 2020 by BrianTRice (talk | contribs) (link update)

(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search

The charging circuit has a fuse encapsulated in a cable that protects the battery from charging at too high a rate.

Affected Circuits
Location
On the right side of the bike under the seat behind the battery, near or under quite a few 12V cable runs.
JJN-100 Fuse.jpg
Fuse Specification
Platform Years Current Limit (Continuous) Power Limit (Continuous) Product
X 2013+
S 2013 30A 3kW Eaton JJN-30
2014+ 100A rated, 85A slow limit 10kW Eaton JJN-100
NOTE
2013 Battery Pack Longevity Recalls
The battery pack replacements performed by the manufacturer due to discovered defects wind up being upgrades to 2015 and then 2016 model year power packs, and seem to include upgraded charging circuits, so those older models will have the higher-rated fuse and work like the newer bikes, charging-wise.
Replacement
Warning Warning: This fuse is not meant to be user-serviceable, and could be very dangerous to replace without the exact same specification.
The fuse is downstream from the contactor, so if the contactor is open (it should be if you can't charge and the bike is keyed off), it should be de-energized.
Verify this with proper testing equipment.
It's a huge inline fuse within adhesive heat shrink, so it's difficult to extract and replace.
The wires do have ring terminals once you get the fuse out, so you could wire in a fuse breaker. Or if in a pinch just bolt them together.
Fuse Part Investigations
A 2014 SR was found to have an Eaton JJN-100 fuse, a fast-acting fuse rated for 300V and 100A.
Datasheet for the Eaton JJN-100
If the 2014 match is correct, a JJN-30 would seem to be the match for a 2013 Zero (same datasheet as above).
There was supposition of a 60A limit on 2014 motorcycles, implying a TTN-60, but that has not been proven with evidence.