5,366
edits
Changes
m
BrianTRice moved page Motor Removal to Gen2/Motor Removal
<onlyinclude>
;Tools
* M8 Allen socket
* Torque wrench
;Steps
# [[Lockout Procedure|Perform a lockout on the powertrain]].
# [[Swingarm Removal|Remove the swingarm]].
#: First you have to remove the swing-arm (that is pretty straight forward) some big bolts in the pivot and disconnet the shock.
#: You can leave the brake lines attached and just move the swingarm out of the way when the motor needs to come out.
# Unplug the sensor connector near the front of the contoller on the riders right side of the bike.
# Un-bolt the 3 phase leads to the motor controller.
#: It's a good idea to insulate them just in case the bike is powered on.
# Disconnect the motor from the bike.
#: On the motor there are 8 M8 bolts holding the motor in place: 4 on the drive side, 4 on the rear side.
#: Those bolts only have about 12Nm of torque on them.
# Once you have the motor disconnected and un-bolted from the frame, it should slide out towards the back.
</onlyinclude>
;References
* [http://electricmotorcycleforum.com/boards/index.php?topic=8813.msg78554#msg78554 Re: Zero fx needs help]
[[Category:Procedure]]
[[Category:Teardown]]
;Tools
* M8 Allen socket
* Torque wrench
;Steps
# [[Lockout Procedure|Perform a lockout on the powertrain]].
# [[Swingarm Removal|Remove the swingarm]].
#: First you have to remove the swing-arm (that is pretty straight forward) some big bolts in the pivot and disconnet the shock.
#: You can leave the brake lines attached and just move the swingarm out of the way when the motor needs to come out.
# Unplug the sensor connector near the front of the contoller on the riders right side of the bike.
# Un-bolt the 3 phase leads to the motor controller.
#: It's a good idea to insulate them just in case the bike is powered on.
# Disconnect the motor from the bike.
#: On the motor there are 8 M8 bolts holding the motor in place: 4 on the drive side, 4 on the rear side.
#: Those bolts only have about 12Nm of torque on them.
# Once you have the motor disconnected and un-bolted from the frame, it should slide out towards the back.
</onlyinclude>
;References
* [http://electricmotorcycleforum.com/boards/index.php?topic=8813.msg78554#msg78554 Re: Zero fx needs help]
[[Category:Procedure]]
[[Category:Teardown]]