5,366
edits
Changes
video embed
This removes the [[Footpegs|passenger footpegs]] from 2012+ S and X-Platform models.
<onlyinclude>
[[File:footpeg-retaining.jpeg|thumb|150px|footpeg retaining clip and tool]]
;Tools
* Snap Ring / E-Ring pliers (needlenose pliers are a common if less easy substitute).
* 13mm hex side or socket wrench (for the bracket).
;Steps
# Gently spread the gap in the retaining E-ring using the pliers until it slides over the end of the pin, and remove it.
#: This clip is on the lower end of the footpeg retaining pin.
# Pull the retaining pin up and out.
#: Hold and pull the pin spring and footpeg as the pin comes out.
# (Optional) Remove the bracket
## Loosen the upper bolts mounting the footpeg brackets to the frame.
##: '''S-platform:''' Reaching these bolts from the rear is easiest since they are on the inside of the frame.
## Loosen the lower bolts mounting the footpeg brackets to the frame.
##: '''S-platform:''' These face the motor and allow very low overhead.
##:: A side wrench is recommended, and a ratcheting version preferred.
## Remove the bolts and then the brackets.
;References
: [https://www.youtube.com/watch?v=9OdBkfS_qbs How to Remove Zero Footpegs + Relocation Ideas] by NewZeroLand on Youtube
: {{#ev:youtube|9OdBkfS_qbs}}
</onlyinclude>
[[Category:Procedure]]
[[Category:Teardown]]
<onlyinclude>
[[File:footpeg-retaining.jpeg|thumb|150px|footpeg retaining clip and tool]]
;Tools
* Snap Ring / E-Ring pliers (needlenose pliers are a common if less easy substitute).
* 13mm hex side or socket wrench (for the bracket).
;Steps
# Gently spread the gap in the retaining E-ring using the pliers until it slides over the end of the pin, and remove it.
#: This clip is on the lower end of the footpeg retaining pin.
# Pull the retaining pin up and out.
#: Hold and pull the pin spring and footpeg as the pin comes out.
# (Optional) Remove the bracket
## Loosen the upper bolts mounting the footpeg brackets to the frame.
##: '''S-platform:''' Reaching these bolts from the rear is easiest since they are on the inside of the frame.
## Loosen the lower bolts mounting the footpeg brackets to the frame.
##: '''S-platform:''' These face the motor and allow very low overhead.
##:: A side wrench is recommended, and a ratcheting version preferred.
## Remove the bolts and then the brackets.
;References
: [https://www.youtube.com/watch?v=9OdBkfS_qbs How to Remove Zero Footpegs + Relocation Ideas] by NewZeroLand on Youtube
: {{#ev:youtube|9OdBkfS_qbs}}
</onlyinclude>
[[Category:Procedure]]
[[Category:Teardown]]