5,366
edits
Changes
extract from service manual
<onlyinclude>
Removing the [[Monolith]] from an [[SDS Platform]] model:
:This is very involved, only suitable for a dealer or experienced electrical engineer equipped with a hoist, because the frame must be lifted vertically off of the battery, and the battery must be electrically detached from the systems safely.
:There is also almost no realistic reason to do this for a battery under warrantee.
;Steps
* These are a rough sketch of the process.
#Remove the belly pan and onboard charger.
#Disconnect all cables leading to the battery.
#Disconnect the grounding strap to the Y-shaped underseat frame piece.
#Place the motorcycle on a center lift that can balance the battery on its own.
#Harness the frame into a hoist and put some of the load onto that hoist.
#:The hoist should be rated to lift the bike's weight entirely.
#(Possibly) remove the front wheel and/or forks.
#(Possibly) remove the rear wheel and/or swingarm.
#Use an allen key wrench to remove the 2 bolts on each side of the lower battery mount (4 total).
#Lift the frame.
</onlyinclude>
[[Category:High Voltage Procedure]]
Removing the [[Monolith]] from an [[SDS Platform]] model:
:This is very involved, only suitable for a dealer or experienced electrical engineer equipped with a hoist, because the frame must be lifted vertically off of the battery, and the battery must be electrically detached from the systems safely.
:There is also almost no realistic reason to do this for a battery under warrantee.
;Steps
* These are a rough sketch of the process.
#Remove the belly pan and onboard charger.
#Disconnect all cables leading to the battery.
#Disconnect the grounding strap to the Y-shaped underseat frame piece.
#Place the motorcycle on a center lift that can balance the battery on its own.
#Harness the frame into a hoist and put some of the load onto that hoist.
#:The hoist should be rated to lift the bike's weight entirely.
#(Possibly) remove the front wheel and/or forks.
#(Possibly) remove the rear wheel and/or swingarm.
#Use an allen key wrench to remove the 2 bolts on each side of the lower battery mount (4 total).
#Lift the frame.
</onlyinclude>
[[Category:High Voltage Procedure]]
