Changes

Jump to: navigation, search

SDS Platform/Tail Extension

1,039 bytes added, 03:53, 21 April 2020
transclude new page
<onlyinclude>
The SDS Platform tail extension supports the license plate, turn signals, and reflectors at a distance from the underside of the tail.

;Construction
: The extension is made of two cast aluminum pieces, upper and lower, that fasten together.

;Wiring
: 12V wiring runs through holes in the bracket's bolted mounting to the underside of the tail to each turn signal.
:: The barrel connector pins for the turn signals are part of the [[SDS Platform/Tail Wiring|wiring inside the tail]] behind the seat.
: 12V wiring runs through the extension to the license plate support bracket to power a low level illuminator bulb.

;Mounting
: The tail extension bolts into the tail subframe using a pattern of 4 M5&times;15 bolts with washers.
: The bolts fasten upwards into the tail subframe; use a 4mm Allen key wrench to remove or replace.

;[[License Plate Bulb]]
{{:License Plate Bulb}}
</onlyinclude>

===[[SDS Platform/Tail Extension Removal|Removal]]===
{{:SDS Platform/Tail Extension Removal}}

[[Category:Structural Component]]

Navigation menu