5,366
edits
Changes
no edit summary
This removes the [[SDS Platform/Y-Shaped Underseat Subframe|Y-Shaped Underseat Frame]].
:[[File:Dsr-under-seat.JPG|thumb|2016 DSR underseat view]]
<onlyinclude>
;Tools
* 10mm hex socket wrench with at least 20mm of depth.
* 5mm Allen key.
;Steps
# [[Seat Removal|Remove the seat]].
# Use the 10mm socket wrench to loosen the locknuts anchoring the forward end of the washers.
# Use the 5mm Allen key to loosen the bolts at each of the rear ends of the frame piece.
# Remove the locknuts and the bolts in a coordinated pattern to avoid putting it under asymmetrical loading.
#* Take care not to lose the washers in the frame piece or in the bike's cabling areas underneath as each bolt and nut comes off.
;Installation
# Ensure the underlying cabling is placed in its original orientation to avoid strain.
# Press the frame piece's fastener holes onto the corresponding threaded bolts on the frame arch over the rear of the battery.
# Align the rear ends of the frame piece with the corresponding frame holes, and thread the bolts with washers gently into position (without tightening) to secure the frame piece.
# Thread (without tightening) the front locknuts with washers onto the forward bolts.
# Tighten the two forward nuts and rear bolts in a coordinated pattern to settle the frame piece into the right load-bearing orientation.
#* Take care while tightening not to strain any cables or wiring underneath the frame piece.
</onlyinclude>
[[Category:Procedure]]
[[Category:Teardown]]
:[[File:Dsr-under-seat.JPG|thumb|2016 DSR underseat view]]
<onlyinclude>
;Tools
* 10mm hex socket wrench with at least 20mm of depth.
* 5mm Allen key.
;Steps
# [[Seat Removal|Remove the seat]].
# Use the 10mm socket wrench to loosen the locknuts anchoring the forward end of the washers.
# Use the 5mm Allen key to loosen the bolts at each of the rear ends of the frame piece.
# Remove the locknuts and the bolts in a coordinated pattern to avoid putting it under asymmetrical loading.
#* Take care not to lose the washers in the frame piece or in the bike's cabling areas underneath as each bolt and nut comes off.
;Installation
# Ensure the underlying cabling is placed in its original orientation to avoid strain.
# Press the frame piece's fastener holes onto the corresponding threaded bolts on the frame arch over the rear of the battery.
# Align the rear ends of the frame piece with the corresponding frame holes, and thread the bolts with washers gently into position (without tightening) to secure the frame piece.
# Thread (without tightening) the front locknuts with washers onto the forward bolts.
# Tighten the two forward nuts and rear bolts in a coordinated pattern to settle the frame piece into the right load-bearing orientation.
#* Take care while tightening not to strain any cables or wiring underneath the frame piece.
</onlyinclude>
[[Category:Procedure]]
[[Category:Teardown]]