Difference between revisions of "Gen2/High Beam Switch Toggle Sculpting"
From Unofficial Zero Manual
< Gen2
BrianTRice (talk | contribs) (set time) |
(No difference)
|
Latest revision as of 21:35, 31 May 2020
- Goal
- This fixes a design/ergonomics issue with 2015+ models, where the high beam toggle is difficult to manipulate.
- Prior to 2015, a large rocker switch operated the high/low beam selector, and no hazard warning toggle was available.
- Steps
- Form a nub shape of Sugru putty and adhere to the lower end of the High Beam Switch slider.
-
- Let it set for a while (30 minutes to 24 hours?) before trying to use it.
- References
