Difference between revisions of "SDS Platform/Controller Uncovering"
From Unofficial Zero Manual
(extracted from manual)
Revision as of 06:57, 2 August 2018
- Small Philips-head screwdriver (PH1)
- Use the Philips head screwdriver to unfasten the rear end of the sheet just aft of the controller in the tail.
- Pull up carefully to raise the edges out from under the tail frame's side rails.
- The forward section of the plastic sheet hooks around the wiring connecting to the controller's AMPSeal 34-pin connector at front; usually this can remain in place but it can be removed by winding it counterclockwise, pulling on the left as it is removed.