Difference between revisions of "SDS Platform/Controller Uncovering"
From Unofficial Zero Manual
BrianTRice (talk | contribs) (extracted from manual) |
BrianTRice (talk | contribs) m (S platform only) |
||
(2 intermediate revisions by the same user not shown) | |||
Line 1: | Line 1: | ||
+ | This uncovers the [[Unofficial Service Manual#Controller|Sevcon controller]] on the S Platform. | ||
+ | |||
<onlyinclude> | <onlyinclude> | ||
+ | ;Prerequisites | ||
+ | * [[Seat Removal|Remove the seat]] | ||
+ | |||
;Tools | ;Tools | ||
* Small Philips-head screwdriver (PH1) | * Small Philips-head screwdriver (PH1) | ||
Line 6: | Line 11: | ||
# Use the Philips head screwdriver to unfasten the rear end of the sheet just aft of the controller in the tail. | # Use the Philips head screwdriver to unfasten the rear end of the sheet just aft of the controller in the tail. | ||
# Pull up carefully to raise the edges out from under the tail frame's side rails. | # Pull up carefully to raise the edges out from under the tail frame's side rails. | ||
− | # | + | # (Optional) Wind the forward section of the plastic sheet counterclockwise around the AMPSeal 34-pin connector, pulling on the left. |
</onlyinclude> | </onlyinclude> | ||
− | |||
[[Category:Teardown]] | [[Category:Teardown]] | ||
+ | [[Category:High Voltage Procedure]] |
Revision as of 19:46, 2 April 2019
This uncovers the Sevcon controller on the S Platform.
- Prerequisites
- Tools
- Small Philips-head screwdriver (PH1)
- Steps
- Use the Philips head screwdriver to unfasten the rear end of the sheet just aft of the controller in the tail.
- Pull up carefully to raise the edges out from under the tail frame's side rails.
- (Optional) Wind the forward section of the plastic sheet counterclockwise around the AMPSeal 34-pin connector, pulling on the left.