Difference between revisions of "Controller Uncovering"

From Unofficial Zero Manual
Jump to: navigation, search
m
m (S platform only)
 
(One intermediate revision by the same user not shown)
Line 1: Line 1:
This uncovers the [[Unofficial Service Manual#Controller|Sevcon controller]].
+
This uncovers the [[Unofficial Service Manual#Controller|Sevcon controller]] on the S Platform.
  
 
<onlyinclude>
 
<onlyinclude>
Line 14: Line 14:
 
</onlyinclude>
 
</onlyinclude>
  
[[Category:Procedure]]
 
 
[[Category:Teardown]]
 
[[Category:Teardown]]
 +
[[Category:High Voltage Procedure]]

Latest revision as of 19:46, 2 April 2019

This uncovers the Sevcon controller on the S Platform.


Prerequisites
Tools
  • Small Philips-head screwdriver (PH1)
Steps
  1. Use the Philips head screwdriver to unfasten the rear end of the sheet just aft of the controller in the tail.
  2. Pull up carefully to raise the edges out from under the tail frame's side rails.
  3. (Optional) Wind the forward section of the plastic sheet counterclockwise around the AMPSeal 34-pin connector, pulling on the left.