Difference between revisions of "SDS Platform/Controller Uncovering"

From Unofficial Zero Manual
Jump to: navigation, search
(extracted from manual)
(No difference)

Revision as of 06:57, 2 August 2018

  • Small Philips-head screwdriver (PH1)
  1. Use the Philips head screwdriver to unfasten the rear end of the sheet just aft of the controller in the tail.
  2. Pull up carefully to raise the edges out from under the tail frame's side rails.
  3. The forward section of the plastic sheet hooks around the wiring connecting to the controller's AMPSeal 34-pin connector at front; usually this can remain in place but it can be removed by winding it counterclockwise, pulling on the left as it is removed.