Difference between revisions of "SDS Platform/Controller Uncovering"

From Unofficial Zero Manual
Jump to: navigation, search
Line 14: Line 14:
[[Category:High Voltage Procedure]]

Revision as of 04:19, 17 August 2018

This uncovers the Sevcon controller.

  • Small Philips-head screwdriver (PH1)
  1. Use the Philips head screwdriver to unfasten the rear end of the sheet just aft of the controller in the tail.
  2. Pull up carefully to raise the edges out from under the tail frame's side rails.
  3. (Optional) Wind the forward section of the plastic sheet counterclockwise around the AMPSeal 34-pin connector, pulling on the left.