From Unofficial Zero Manual
Revision as of 19:46, 2 April 2019 by BrianTRice (S platform only)
This uncovers the Sevcon controller on the S Platform.
- Small Philips-head screwdriver (PH1)
- Use the Philips head screwdriver to unfasten the rear end of the sheet just aft of the controller in the tail.
- Pull up carefully to raise the edges out from under the tail frame's side rails.
- (Optional) Wind the forward section of the plastic sheet counterclockwise around the AMPSeal 34-pin connector, pulling on the left.