Gen2/Charging Control Unit

From Unofficial Zero Manual
< Gen2
Revision as of 23:04, 29 March 2020 by BrianTRice (talk | contribs)

(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search

The Charging Control Unit (CCU) on Meanwell-charger-equipped models (all 2013 and the 2014FX) collects battery temperature sensor data, battery voltage, and charger DC voltage to decide on whether to open or close the contactor. It also manages the Meanwell onboard charger which has no CANBus connection or programmability, so when the programmable Calex charger was introduced, the CCU's functions were moved to direct BMS/MBB management.

CCU top
CCU back
CCU front
Connectors
CCU 18-pin connector: JAE Electronics MX23A18SF1
2013 CCU Connector diagram
Ccu-connector-schem.png
TODO
more from Burton's post here: Re: 2013 S 11.4 quick charger build

The contactor protects the battery against faults. It is analogous to a circuit breaker. The CCU directs it.

2012-2013 models exhibited behavior where the BMS in certain situations yielded a "contactor welded shut" condition that require dealer servicing. Later model years fail more safely (open).

2014+ models do not have a CCU, and the BMS directly controls the contactor and onboard charger.

Location
Under the seat in front of the MBB with the connections mounted on top.
Limits
The CCU terminals are not designed for high amperage currents. Presumably, anything above the 2013's intended 30A charging limit could damage the CCU or trigger the contactor opening.
Warning Warning: This is always energized. Any exposure of this at any time will risk direct contact with battery terminals that could result in injury or equipment damage.
DO NOT UNCOVER this without professional-level care!

If you are in a remote location, and have trouble with a contactor unit not closing without any indication of a particular condition that interlocks it in the BMS, a little mild mechanical agitation (while the vehicle is keyed off) against the top surface with a rubber mallet might loosen it.