Difference between revisions of "SDS Platform/Controller Uncovering"

From Unofficial Zero Manual
Jump to: navigation, search
m (S platform only)
(No difference)

Revision as of 00:25, 7 December 2019

This uncovers the Sevcon controller on the S Platform.

  • Small Philips-head screwdriver (PH1)
  1. Use the Philips head screwdriver to unfasten the rear end of the sheet just aft of the controller in the tail.
  2. Pull up carefully to raise the edges out from under the tail frame's side rails.
  3. (Optional) Wind the forward section of the plastic sheet counterclockwise around the AMPSeal 34-pin connector, pulling on the left.