SDS Platform/Tail Wiring

From Unofficial Zero Manual
< SDS Platform
Revision as of 22:46, 15 April 2020 by BrianTRice (talk | contribs) (new category)

(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search

Tail wiring includes the tail lights (running and braking power), each rear turn signal, and the license plate illuminator.

Connections
Photo Connector Function Wire Color
ZeroTail17b.jpg Standard Suzuki or Honda brake light (3-wire) Tail light power Brown
Brake light power White with red stripe
Negative/Return Black
Single pin connector
Socket: Molex 03-09-2011 [1] [2]
Pin: Molex 03-09-1011 [3]
Left turn signal power Green
Negative/Return Black
Right turn signal power Grey
Negative/Return Black
Note about Braking Regen
Braking regen is activated by the pressure switch on the front brake lever or hydraulic switch on the rear brake pedal, through the rear brake power circuit.
If that circuit doesn't complete (due to a failed bulb or wiring disconnect), braking regen seems to not activate.
Routing
Tail wiring runs through a sleeve by the controller on the left side.
Ensure it is protected from chafing by the controller cover.
Turn signal wires run through a pair of holes where the tail stalk meets the subassembly underneath the tail.