SDS Platform/Controller Uncovering
From Unofficial Zero Manual
< SDS Platform(Redirected from Controller Uncovering)
This uncovers the motor controller on the SDS Platform.
 Warning: | This exposes high-voltage terminals that can damage tools, equipment, or cause injury or death if not de-energized. Ensure the bike is fully de-energized or that you are using professional methods and safety precautions. |
- Prerequisites
- Tools
- Small Philips-head screwdriver (PH1)
- Steps
- Use the Philips head screwdriver to unfasten the rear end of the sheet just aft of the controller in the tail.
- Pull up carefully to raise the edges out from under the tail frame's side rails.
- (Optional) Wind the forward section of the plastic sheet counterclockwise around the AMPSeal 34-pin connector, pulling on the left.
