Changes

Jump to: navigation, search

Controller Uncovering

583 bytes added, 06:57, 2 August 2018
extracted from manual
<onlyinclude>
;Tools
* Small Philips-head screwdriver (PH1)

; Steps
# Use the Philips head screwdriver to unfasten the rear end of the sheet just aft of the controller in the tail.
# Pull up carefully to raise the edges out from under the tail frame's side rails.
# The forward section of the plastic sheet hooks around the wiring connecting to the controller's AMPSeal 34-pin connector at front; usually this can remain in place but it can be removed by winding it counterclockwise, pulling on the left as it is removed.
</onlyinclude>

[[Category:Procedure]]
[[Category:Teardown]]

Navigation menu