5,366
edits
Changes
no edit summary
This uncovers the [[Gen2/Motor Controller|motor controller]] on the [[SDS Platform]].
<onlyinclude>
{{warning|This exposes high-voltage terminals that can damage tools, equipment, or cause injury or death if not de-energized.
Ensure the bike is fully de-energized or that you are using professional methods and safety precautions.}}
;Prerequisites
* [[SDS Platform/Seat Removal|Remove the seat]]
;Tools
* Small Philips-head screwdriver (PH1)
; Steps
# Use the Philips head screwdriver to unfasten the rear end of the sheet just aft of the controller in the tail.
# Pull up carefully to raise the edges out from under the tail frame's side rails.
# (Optional) Wind the forward section of the plastic sheet counterclockwise around the AMPSeal 34-pin connector, pulling on the left.
</onlyinclude>
[[Category:Teardown]]
[[Category:High Voltage Procedure]]
<onlyinclude>
{{warning|This exposes high-voltage terminals that can damage tools, equipment, or cause injury or death if not de-energized.
Ensure the bike is fully de-energized or that you are using professional methods and safety precautions.}}
;Prerequisites
* [[SDS Platform/Seat Removal|Remove the seat]]
;Tools
* Small Philips-head screwdriver (PH1)
; Steps
# Use the Philips head screwdriver to unfasten the rear end of the sheet just aft of the controller in the tail.
# Pull up carefully to raise the edges out from under the tail frame's side rails.
# (Optional) Wind the forward section of the plastic sheet counterclockwise around the AMPSeal 34-pin connector, pulling on the left.
</onlyinclude>
[[Category:Teardown]]
[[Category:High Voltage Procedure]]
