Changes

SDS Platform/Charging Cable Routing

1,054 bytes added, 00:01, 19 April 2020
stub article
<onlyinclude>
The charging cables transmit power from the [[Onboard Charger]] and the [[Gen2/Accessory Charging Port|accessory charging port]] to the main power packs via the main bus.

;Routing
* [[SDS Platform]]
*: On 2014+ models with Calex chargers, the [[Onboard Charger]] DC output cable runs along the right side of the rear face of the [[Monolith]] compartment, where it joins via Anderson SB50(?) brown connector to the charging circuit to the main pack.
*: The [[Gen2/Accessory Charging Port|accessory charging port]] cable runs forward from the underside of the [[SDS Platform/Board Mounting Plate|board mounting plate]] up through the [[Gen2/Charging Circuit Fuse|charging circuit fuse]] to the main pack.
*: Since the main pack may be a 3 or 4-brick [[Monolith]] or a [[Longbrick]], the routing varies in how it reaches either the doghouse or the back plane of the battery.
* [[XMX Platform]]
*: See [[XMX Platform/Electrical Routing|the XMX electrical routing article]] to see the layout of these cables.
</onlyinclude>

[[Category:Wiring]]