View source for BMS CANBus Loopback

Jump to: navigation, search

You do not have permission to edit this page, for the following reasons:

  • The action you have requested is limited to users in the group: Administrators.
  • You must confirm your email address before editing pages. Please set and validate your email address through your user preferences.

You can view and copy the source of this page.

BoldItalic
External link (remember http:// prefix)Internal linkEmbedded fileReference
AdvancedSpecial charactersHelp
​x
 
<onlyinclude>
BMS CANBus loopback is a function of the built-in cable communications support for the [[Power Tank]] or the second [[Power Pack Module]] in a non-longbrick X platform model (labeled ''BMS1'' by the MBB).
​
The cabling ends in a multi-pin connector and should either:
# Terminate with a [[Loopback Blanking Plug]] that wires two pins together in a ''loopback'' circuit.
# Connect to a [[Power Tank]]'s corresponding communications cable.
​
If one of the above conditions do not hold, the MBB is configured to issue [[Error Codes#35|error code 35]].
: It is unconfirmed what purpose the loopback mechanism serves.
: ''Hypothesis:'' This is a hardware debugging mechanism for a loose connector.
</onlyinclude>
​
[[Category:Explanation]]
​

Return to BMS CANBus Loopback.

Retrieved from "http://zeromanual.com/wiki/BMS_CANBus_Loopback"