Difference between revisions of "SDS Platform/Tail Extension Removal"

Latest revision as of 03:55, 21 April 2020

This removes the tail extension from SDS Platform models.

The tail extension bolts into the tail subframe using a pattern of 4 M5×15 bolts with washers.

The bolts fasten upwards into the tail subframe.

Tools

• 4mm (H4) Allen key wrench.

Steps

1. Remove the seat.
2. Disconnect tail turn signal wires.
3. Use the 4mm Allen key wrench to loosen the bolts.

   Suspend the tail extension as you remove each bolt to avoid it just falling haphazardly.

When re-attaching, take care to insert the tail turn signal wires upwards through the holes into the tail area.

Also mind how the rear mounting bolts tighten so as not to pinch these wires.