Difference between revisions of "MBB Hardware Reset"

Latest revision as of 17:45, 22 April 2020

This is a fallback procedure for when the vehicle is disabled and a BMS Reset has already been fully attempted with no success.

Steps

1. Turn off the vehicle fully.
2. Access the MBB:
   • SDS Platform: Remove the seat.
   • XMX Platform: Uncover the left panel below the battery compartment.
   • FST Platform: Remove the tank.
3. Pull the two multi-pin cables off of the MBB.
4. Wait a while (30 seconds, say).
5. Reconnect the two multi-pin cables to the MBB.

   Ensure the cables are fully seated and locked into place.

6. Re-test by powering the bike on.
7. Correct the MBB internal clock/date as necessary.

References

"After pulling the two cables on the Main Bike Board (MBB) 30 secs the contractor closed en all worked well again."