SDS Platform/12V Accessory Socket Kit Install

This installs 12V Accessory Socket Kit for 2014+ S Platform models.

12V Accessory Wiring Harness for 2013+ S Platform models also applies.

Reference Video

• AIKI Rob's Zero DSR usb accessory and helmet mods:

Steps

1. Loosen collet from accessory kit and set aside

   

   12V accessory kit with loosened collet

2. Remove rubber blank from the right-side plastic shoulder piece around the instrument cluster.

   

   12V port rubber blank removed from the shoulder piece

   This is now an extra part you will not be needing while the accessory power kit is installed.

3. Feed the wire assembly through the hole in dash and align the 12v socket key into the keyway of the hole in the dash.

   

   wire fed through hole

   

   port aligned in hole

   You may want to undo the right-hand turn signal light 2x 3mm mushroom socket head bolts, to get better access and visibility.

4. Return collet over wire assembly and rotate to fasten the 12v socket into place.

   Take care not to pinch the turn signal wires.

   

   collet along wires

5. Route wires to left-hand side and into compartment.

   

   routing the wires across to the left

6. Remove rubber protective boot from Sumitomo socket and connect to 12v accessory socket wiring Sumitomo plug.

   

   Sumitomo location

   

   Sumitomo connected

7. Button up everything. You are done!