Turn Signal Flasher

The turn signal ("blinker") flasher is a simple three prong flasher relay.

It's attached directly by a plug so is easily replaced if it fails (or for an LED compatible unit).

Label

Flasher Unit 12V
2x10W
PN: 8078
Made by Ecie Cheng Du

or

GUILERA
Flasher Unit 12V
10+10W+1,2W
P.N. 013341

Low Noise Revision

As of 2016, the part is revised with the description "low noise".

This suggests reduced electronic and/or audible noise.

This model of flasher relay is noticeably quieter, and that year coincides with reports from Zero management of EU EMF/EMC noise compliance expenditures.

Silent Revision

As of 2020?, the part is from the manufacturer Guilera and makes no audible noise.

This again suggests reduced electronic noise, again likely as a result of EU EMF/EMC noise compliance expenditures.

Wiring

The orientation is specific. Reversing the (+) and (-) wiring may be necessary if you buy the wrong orientation of relay.

Look at the pins with the middle L (center)(Load) pin on top and the B and E below it to each side.

• 2018+: The orientation should be E (-) (left), L (center/top), then B (+) (right).

  Ref. report from a 2019S owner

  This orientation is know as a CF14 relay per pacificcricket

• 2013-2017:

  The orientation should be B (+) (left), L (center/top), then E (-) (right)

  This orientation is know as a CF13 relay

Flasher Location

Years	Platform	Location	Photo
2012	S/X	Under the seat below the fuse block.
2013+	X	Behind the right fairing
	S	In front of the front plastics area under the frame "wishbone" with other electrical connections.