Gen2/Instrument Cluster/Indications

This helps navigate the Gen2 instrument cluster's indications with some interpretation guides.

Gen2 Instrument Cluster Official Line Drawing

Gen2 Instrument Cluster Stock Photo

Indications (left to right, descending)

Area	Indicator	Source	Adjustment
Left	Clock	Internal Powered by a non-replaceable battery	SEL+ADJ
	Time to Charge	MBB	Projected remaining time estimate in hours and minutes.
	SoC	MBB	MBB settings Fuel Gauge Pessimism NOTE: The indicator skips 81,61,41,21, and 1.
	Bluetooth Indicator		After key-on or the first minutes of charging Unless/until a mobile device pairs See Unable to Connect and Pairing
Center	Speed		MBB settings Sprocket Teeth Front Sprocket Teeth Rear Rear Wheel Circum
	Odometer	Stored in the unit's memory	Unalterable If stuck/frozen, the likely cause is that the MBB has misconfigured model information. Have a dealer examine and correct it, which should propagate an updated reading to this indicator.
	A	MBB	To toggle: Press SEL once so that this blinks. Press ADJ to cycle through: Trip 1 odometer (resets after a full charge or manually). Units are mi or km. Range estimate, based on a projection tuned by recent ride history. Units are mi or km. Error cycling through the Error Codes RPM motor rotational speed. Units are RPMs.
	B		To toggle: Press SEL twice so that this blinks. Press ADJ to cycle through: Trip 2 odometer (resets only manually). Units are mi or km. Trip AV average efficiency over Trip 1 as Energy/Distance = Power/Speed. Units are Wh/mi or Wh/km. Temp motor temperature only. Units are °F or °C. Trip AV average efficiency over vehicle lifetime as Energy/Distance = Power/Speed. Units are Wh/mi or Wh/km.
Right	Drive Mode		mode selector switch on right handlebar
	Power		Throttle
	Torque
Bottom	Left Turn Signal Indicator		Left handlebar turn signal switch
	System Warning Indicator		Check System Warning Sequences
	Temperature Warning Indicator		Controller, Motor, or Battery Temperatures at Stage 1
	Check Engine Indicator (2018+)		Error Codes triggered permanent torque reduction
	Drive Mode Enabled		Green light is: Solid when contactor shut and cutout disengaged Blinking when precharging Disabled/off by cutout or interlock
	ABS Indicator		Whether anti-lock braking is operational: On just after startup before reaching 3mph when the ABS tone rings align fully Off while riding unless ABS is engaged. On while riding if ABS is engaged because of a difference between wheel rotational speeds.
	Charging Indicator		Green LED is: Flashing when charging Solid when full Off when riding
	High Beam Indicator		Left handlebar headlamp switch
	Right Turn Signal Indicator		Left handlebar turn signal switch

Controls

Select Button

Interactions:

• Using momentary presses cycles through display regions to adjust:
  1. Display A
  2. Display B
• Using an extended press for a few seconds enters an alternate cycle of the other display regions to adjust:
  1. Speed indicator units
  2. Clock (hours)
  3. Clock (minutes)
  4. Display B's Temp indicator units

Adjust Button

Interactions:

• Press and hold for a few seconds to reset the currently-displayed Trip meter.
• After using the Select Button to highlight an indication press momentarily to cycle through whatever it can.