Difference between revisions of "SDS Platform/Y-Shaped Underseat Subframe"

From Unofficial Zero Manual
Jump to: navigation, search
 
(No difference)

Latest revision as of 01:44, 7 April 2020

2016 DSR underseat view

This frame piece spans the top of the frame between the part that sits behind the battery doghouse and the tail.

Functions
  • Support and anchor the seat by two pins extending from the forward center section.
  • Anchor the rear of the tank plastics.
  • Mount the 12V Fuse Block on the left rear leg.
  • Distributes the seat loading between the forward frame bracket arching over the monolith, and the horns of the rear tail.
    This protects underlying cabling, as well as dampens any load on the frame that would flex the tail relative to the forward part of the frame.
  • Removable (vs being frame-integrated or welded) for servicing everything above the motor (MBB, DC-DC converter, and cabling and wiring).
Mounting
  • Forward: 2x 10mm hex nylon locknuts, with washers.
  • Rear: 2x M5 socket cap bolts, 20mm length with a 2mm shoulder, 1mm depth, 6mm outer diameter, with washers.
Removal
Tools
  • 10mm hex socket wrench with at least 20mm of depth.
  • 5mm Allen key.
Steps
  1. Remove the seat.
  2. Use the 10mm socket wrench to loosen the locknuts anchoring the forward end of the washers.
  3. Use the 5mm Allen key to loosen the bolts at each of the rear ends of the frame piece.
  4. Remove the locknuts and the bolts in a coordinated pattern to avoid putting it under asymmetrical loading.
    • Take care not to lose the washers in the frame piece or in the bike's cabling areas underneath as each bolt and nut comes off.
Installation
  1. Ensure the underlying cabling is placed in its original orientation to avoid strain.
  2. Press the frame piece's fastener holes onto the corresponding threaded bolts on the frame arch over the rear of the battery.
  3. Align the rear ends of the frame piece with the corresponding frame holes, and thread the bolts with washers gently into position (without tightening) to secure the frame piece.
  4. Thread (without tightening) the front locknuts with washers onto the forward bolts.
  5. Tighten the two forward nuts and rear bolts in a coordinated pattern to settle the frame piece into the right load-bearing orientation.
    • Take care while tightening not to strain any cables or wiring underneath the frame piece.